The rotating cradle can be twisted into position to restrain all bike frames no matter the bike geometry. The high density rubber lining and manual-pull ratchet strap means carbon frames won't get damaged.
Quick to fit
The ratchet straps in the cradle and the wheel trays means loading bikes onto an Enduro is even faster.
In a pack:
4x ratchet strap
2x ratchet strap and cradle combination
Compatible with Enduro racks (pre 2019)
250 mm L x 15 mm W x 6 mm D
When upgrading an Enduro 2 - you need 1x Ratchet Upgrade Kit
When upgrading an Enduro 4 - you need 2x Ratchet Upgrade Kit
Unscrew the struts supporting the riser tube. Unscrew the end caps of the riser tube and remove both the end caps and cross-bars.
Slide the rotating cradle up the riser tube, past the strut fixing point. Replace the end caps of the riser tube and the cross-bars. Remount the struts to the riser tube.
Position the wheel tray at the desired location along the cross-bar. Pass the M6 bolt through the clip (ensure the clip is facing up), through the wheel tray then through the base of the ratchet strap and secure with the provided wingnut. Tighten the wingnut until the ratchet strap is secure but can still pivot about the wheel tray.